Top of paper Jam caused by a Paper was not fed in Remove the paper stopped between the paper feed delay. Outer Chute Outer chute tray Fig. Measure the voltages between the terminals. Yes Turn off the power switch, reconnect the connector and turn the power switch on again. Take the corrective actions for the error message. When opening the front cover or back cover to access any parts inside the printer, never touch the shaded parts shown in the following figures. The Drum LED alternates turning on for 2 seconds and off for 3 seconds alternately.
|Date Added:||27 May 2013|
|File Size:||65.88 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Wire solder made in the contries except Pronter are under investigation, and will be evaluated. The toner is charged brother hl-5030 printer carried from the supply roller to the development roller. Clean the toner is faint.
Laser Printer | HL
The printer prints a test page. See the computer manual. Printout is not correct.
Check if there is any play. We brother hl-5030 printer strongly recommend that you continue to use only Genuine Brother Brand replacement toner cartridges. Please see your software application manual. Applicable safety standards have been complied with. Interleaved 2 of 5.
Brother HL-5030 Printer Drivers Download
Envelopes that are damaged, curled, wrinkled, or irregularly shaped Envelopes that are extremely shiny or highly textured Envelopes with clasps, snaps or tie strings Envelopes with self-adhesive closures Envelopes of baggy construction Envelopes that are not sharply creased Embossed envelopes Envelopes that were previously printed by a laser printer Envelopes that are pre-printed on the inside Envelopes that cannot be arranged uniformly when placed in a pile Envelopes constructed brother hl-5030 printer paper that exceeds the paper weight specifications for the printer.
Brother hl-5030 printer cover Paper tray Fig. Yes This problem may appear under the specified system environment.
Brother hl-5030 printer Wipe it off with a soft clean paper. If there is a paper jam, see 4. If you Input “. No Reconnect the connector correctly.
The PS driver does not support manual duplex printing. Do not reset the drum brother hl-5030 printer when replacing hl-50300 toner cartridge only. No Refer and compare with Yes 1 Check and clean the heat roller with a cloth dampened brlther alcohol.
The printer status monitor program can show the current status of your printer.
Print speed varies depending on the paper size or media type. If the pressure plate is deformed, paper feeding problems may occur.
Scratch on the heat roller 5 Is the surface of the heat roller scratched? Brother hl-5030 printer not put more than one piece printr paper in the manual feed tray at any one time, or it may cause a jam.
Do not subject the printer to strong physical shocks or vibrations. A rough surfaced paper may cause the problem.
Brother HL-5030 Consumables
Connect the AC power cord to the printer. If both of the two LEDs are off, then the print server is not connected to the network. This warm-up time can take up to brother hl-5030 printer seconds.
brother hl-5030 printer The flow of printdr ion charge is controlled by the grid to ensure it is distributed evenly on the drum surface.
OB or later of this software, because earlier versions will not work with Brother print servers. For a PCB brother hl-5030 printer an “LF” indication on it, neither tin-lead solder nor lead-free solder with a different metal composition must be used. Yes The photosensitive drum was scratched.